Substitusi Parsial Batu Apung Sebagai Agregat Kasar Pada Campuran Beton

Abdul Gaus, Mufti Amir Sultan, Raudha Hakim, Imran Imran, Inggrayani Anggreni waiola

Abstract


This article discusses lightweight concrete that uses pumice as a substitute for a portion of normal coarse aggregate. The pumice used comes from the Rum quarry of North Maluku Tidore Island. Discussion of research results based on the results of testing in the laboratory. The test aims to find out the optimum composition of the use of pumice as a lightweight concrete aggregate. Tests are carried out on cylindrical specimens 15 x 30 cm with pumice composition compared to normal coarse aggregate of 0:100, 25:75, 50:50, 75:25, and 100: 0. The compressive strength test results obtained the optimum composition of pumice substitution at 25% with a compressive strength of 14,72 MPa with the optimum composition. Density of concrete with pumice aggregate which is included in lightweight concrete at a composition of 75% by weight of pumice against normal aggregate with a concrete weight of 1828,73 kg / m3 lighter 14,40% compared to normal concrete.


Full Text:

PDF

References


SNI 03-2834, Tata Cara Pembuatan Rencana Campuran Beton Normal, Badan

Standardisasi Nasional, pp. 1–34, 2000.

SNI 03-2461, Spesifikasi Agregat Ringan Untuk Beton Ringan Struktural, in Badan

Standardisasi Nasional, 2002.

Y. J. Priyono and N. Nadia, Pengaruh Penggunaan Styrofoam Sebagai Pengganti

Agregat Kasar Terhadap Kuat Tekan Beton, J. Konstr., vol. 5, no. 2, pp. 55–61, 2014.

A. Ginting, Pengaruh Penambahan Styrofoam Terhadap Kuat Tekan dan Kuat Lentur

Beton, J. Tek. Skala, vol. 4, no. 2, pp. 1–7, 2017.

P. Ala and H. Arruan, Beton Ringan Menggunakan Styrofoam Sebagai Bahan Pengganti

Agregat Kasar, in Prosiding Seminar Hasil Penelitian (SNP2M) 2017, 2017, vol., pp. 67–

K. Miswar, Beton Ringan Dengan Menggunakan Limbah Styrofoam, Portal J. Tek. Sipil,

vol. 10, no. 1, pp. 33–39, 2018.

E. Rommel, Pembuatan Beton Ringan dari Aggregat Buatan Berbahan Plastik, J.

Gamma, vol. 9, no. 1, pp. 137–147, 2013.

G. Pamudji, F. Asriani, and A. Fauzi, Kekuatan Lentur Balok Beton Ringan Beragregat

Sampah Plastik PP, in Seminar Nasional “Pengembangan Sumber Daya Perdesaan dan

Kearifan Lokal Berkelanjutan IX,” 2019, vol. 9, no. November, pp. 82–88.

E. Jumiati and M. Masthura, Pembuatan Beton Ringan Berbasis Sampah Organik, J. Ilmu

Fis. dan Teknol., vol. 2, no. 1, pp. 15–22, 2018.

M. Geoffrey, N. M. Raphael, O. Walter, and O. A. Silvester, Properties of Pumice

Lightweight Aggregate, Civ. Environ. Res., vol. 2, no. 10, pp. 58–68, 2012.

I. G. A. N. Purnawirati, I. M. A. K. Salain, and D. Putra, Properti Mekanik Beton Ringan

Dengan Menggunakan Agregat Batu Apung Serta Abu Terbang Sebagai Pengganti

Sebagian Semen Portland dan Superplasticizer, J. Spektran, vol. 4, no. 2, pp. 27–35,

C. R. Nainggolan, I. Wijatmiko, and A. Wibowo, Flexural Behavior of Reinforced

Concrete Beam With Polymer Coated Pumice, AIP Conf. Proc., vol. 1887, no.

September, 2017.

S. Eliazer et al., Perilaku Mekanis Beton Menggunakan Batuan Vulkanik (Batu Angus

dan Batu Apung), J. Tekno, vol. 17, no. 71, pp. 17–20, 2019.

I. Indrayani, A. Herius, A. Hasan, and A. Mirza, The Effect of Addition on Pumice and

Fiber on Compressive and Fluxural Strength Precast Lightweight Concrete, Sci. Technol.

Indones., vol. 5, no. 1, p. 14, 2020.

B. M. A. Herki, Lightweight Concrete Using Local Natural Lightweight Aggregate, J.

Crit. Rev., vol. 7, no. 4, pp. 490–497, 2020.

F. Darwis, M. A. Sultan, and C. Anwar, Pengaruh Variasi Faktor Air Semen Terhadap

Kuat Tekan Beton Beragregat Batu Apung, SIPILsains, vol. 06, no. 11, pp. 31–38, 2016.

M. A. Sultan and M. T. Yudasaputra, Pengaruh Tekanan pada Pembuatan Bata Semen,

in Prosiding Simposium II – UNIID 2017, 2017, no. 1, pp. 360–364.

M. A. Sultan, K. Kusnadi, and M. T. Yudasaputra, Effect of Pressure on Making oof

Cemen Bricks from Pumice, Int. J. Civ. Eng. Technol., vol. 9, no. 5, p. 134, 2018.

M. A. Sultan, M. T. Yudasaputra, and A. Gaus, The Use of Pumice as Raw Material for

Cement Brick, Int. J. Civ. Eng. Technol., vol. 10, no. 12, pp. 498–504, 2019.

SNI 03-1974, Metode Pengujian Kuat Tekan Beton, in Badan Standardisasi Nasiona

Indonesia, 1990.

SNI 03-2834, Tata Cara Pembuatan Rencana Campuran Beton Normal, in Badan

Standardisasi Indonesia, 2002.




DOI: https://doi.org/10.35308/jts-utu.v6i2.2743

Refbacks

  • There are currently no refbacks.


Copyright (c) 2020 Jurnal Teknik Sipil dan Teknologi Konstruksi