Substitusi Parsial Batu Apung Sebagai Agregat Kasar Pada Campuran Beton
Abstract
This article discusses lightweight concrete that uses pumice as a substitute for a portion of normal coarse aggregate. The pumice used comes from the Rum quarry of North Maluku Tidore Island. Discussion of research results based on the results of testing in the laboratory. The test aims to find out the optimum composition of the use of pumice as a lightweight concrete aggregate. Tests are carried out on cylindrical specimens 15 x 30 cm with pumice composition compared to normal coarse aggregate of 0:100, 25:75, 50:50, 75:25, and 100: 0. The compressive strength test results obtained the optimum composition of pumice substitution at 25% with a compressive strength of 14,72 MPa with the optimum composition. Density of concrete with pumice aggregate which is included in lightweight concrete at a composition of 75% by weight of pumice against normal aggregate with a concrete weight of 1828,73 kg / m3 lighter 14,40% compared to normal concrete.
Full Text:
PDFReferences
SNI 03-2834, Tata Cara Pembuatan Rencana Campuran Beton Normal, Badan
Standardisasi Nasional, pp. 1–34, 2000.
SNI 03-2461, Spesifikasi Agregat Ringan Untuk Beton Ringan Struktural, in Badan
Standardisasi Nasional, 2002.
Y. J. Priyono and N. Nadia, Pengaruh Penggunaan Styrofoam Sebagai Pengganti
Agregat Kasar Terhadap Kuat Tekan Beton, J. Konstr., vol. 5, no. 2, pp. 55–61, 2014.
A. Ginting, Pengaruh Penambahan Styrofoam Terhadap Kuat Tekan dan Kuat Lentur
Beton, J. Tek. Skala, vol. 4, no. 2, pp. 1–7, 2017.
P. Ala and H. Arruan, Beton Ringan Menggunakan Styrofoam Sebagai Bahan Pengganti
Agregat Kasar, in Prosiding Seminar Hasil Penelitian (SNP2M) 2017, 2017, vol., pp. 67–
K. Miswar, Beton Ringan Dengan Menggunakan Limbah Styrofoam, Portal J. Tek. Sipil,
vol. 10, no. 1, pp. 33–39, 2018.
E. Rommel, Pembuatan Beton Ringan dari Aggregat Buatan Berbahan Plastik, J.
Gamma, vol. 9, no. 1, pp. 137–147, 2013.
G. Pamudji, F. Asriani, and A. Fauzi, Kekuatan Lentur Balok Beton Ringan Beragregat
Sampah Plastik PP, in Seminar Nasional “Pengembangan Sumber Daya Perdesaan dan
Kearifan Lokal Berkelanjutan IX,” 2019, vol. 9, no. November, pp. 82–88.
E. Jumiati and M. Masthura, Pembuatan Beton Ringan Berbasis Sampah Organik, J. Ilmu
Fis. dan Teknol., vol. 2, no. 1, pp. 15–22, 2018.
M. Geoffrey, N. M. Raphael, O. Walter, and O. A. Silvester, Properties of Pumice
Lightweight Aggregate, Civ. Environ. Res., vol. 2, no. 10, pp. 58–68, 2012.
I. G. A. N. Purnawirati, I. M. A. K. Salain, and D. Putra, Properti Mekanik Beton Ringan
Dengan Menggunakan Agregat Batu Apung Serta Abu Terbang Sebagai Pengganti
Sebagian Semen Portland dan Superplasticizer, J. Spektran, vol. 4, no. 2, pp. 27–35,
C. R. Nainggolan, I. Wijatmiko, and A. Wibowo, Flexural Behavior of Reinforced
Concrete Beam With Polymer Coated Pumice, AIP Conf. Proc., vol. 1887, no.
September, 2017.
S. Eliazer et al., Perilaku Mekanis Beton Menggunakan Batuan Vulkanik (Batu Angus
dan Batu Apung), J. Tekno, vol. 17, no. 71, pp. 17–20, 2019.
I. Indrayani, A. Herius, A. Hasan, and A. Mirza, The Effect of Addition on Pumice and
Fiber on Compressive and Fluxural Strength Precast Lightweight Concrete, Sci. Technol.
Indones., vol. 5, no. 1, p. 14, 2020.
B. M. A. Herki, Lightweight Concrete Using Local Natural Lightweight Aggregate, J.
Crit. Rev., vol. 7, no. 4, pp. 490–497, 2020.
F. Darwis, M. A. Sultan, and C. Anwar, Pengaruh Variasi Faktor Air Semen Terhadap
Kuat Tekan Beton Beragregat Batu Apung, SIPILsains, vol. 06, no. 11, pp. 31–38, 2016.
M. A. Sultan and M. T. Yudasaputra, Pengaruh Tekanan pada Pembuatan Bata Semen,
in Prosiding Simposium II – UNIID 2017, 2017, no. 1, pp. 360–364.
M. A. Sultan, K. Kusnadi, and M. T. Yudasaputra, Effect of Pressure on Making oof
Cemen Bricks from Pumice, Int. J. Civ. Eng. Technol., vol. 9, no. 5, p. 134, 2018.
M. A. Sultan, M. T. Yudasaputra, and A. Gaus, The Use of Pumice as Raw Material for
Cement Brick, Int. J. Civ. Eng. Technol., vol. 10, no. 12, pp. 498–504, 2019.
SNI 03-1974, Metode Pengujian Kuat Tekan Beton, in Badan Standardisasi Nasiona
Indonesia, 1990.
SNI 03-2834, Tata Cara Pembuatan Rencana Campuran Beton Normal, in Badan
Standardisasi Indonesia, 2002.
DOI: https://doi.org/10.35308/jts-utu.v6i2.2743
Refbacks
- There are currently no refbacks.
Copyright (c) 2020 Jurnal Teknik Sipil dan Teknologi Konstruksi