ANALISA MORTAR DENGAN SUBSITUSI AGREGAT ABU KERAK BOILER TERHADAP KUAT TEKAN PADA PAVING BLOCK

Muhammad Irwansyah, Neni Mariani, Teuku Farizal

Abstract


Mortar is a mixture of water, fine aggregate, portland cement or other hydraulic adhesive materials, and other additives that improve the quality of mortar. Ground surfaces such as sidewalks, yards, parking, and light paving are covered by block paving. The purpose of this study was to find out how the replacement of sand affects the quality of compressive strength of mortar to be mixed with boiler scale ash. Experiments were conducted at the Civil Engineering Laboratory of Asahan University to use a composition of replacing sand containing boiler scale ash as much as ten, thirty, and fifty per cent of the weight of sand. As a sample, a standard hexagon paving block test specimen with a thickness of 8 cm is used. Nine samples total, three for each variation and three for each variation. After receiving treatment before testing, the sample was tested at 28 days of age. According to the study, the mixture of sand replacement mortar with 50% boiler scale ash has the highest compressive strength of 12.78 MPa at 28 days of concrete life, while the mortar mixture with 10% boiler scale ash has the lowest compressive strength of 8.15 MPa.

Keywords  mortar, boiler scale ash, compressive strength, paving block


Full Text:

PDF

References


M. S. Hidayat, A. Hasibuan, B. Harahap, and S. P. Nasution, “Pemanfaatan tandan kosong kelapa sawit sebagai bahan pupuk di PT Karya Hevea Indonesia,” Fact. J. Ind. Manaj. dan Rekayasa Sist. Ind., vol. 1, no. 2, pp. 52–58, 2022, doi: 10.56211/factory.v1i2.172.

S. M. Sopa, R. Fajarfika, D. Nurdiana, and A. Y. Rismayanti, “Pemberian berbagai dosis kompos tandan kosong dan Abu boiler limbah kelapa sawit terhadap pertumbuhan dan hasil tanaman kacang tanah (Arachis hypogaea L.),” JAGROS J. Agroteknologi dan Sains (Journal Agrotechnology Sci., vol. 6, no. 1, p. 12, 2022, doi: 10.52434/jagros.v6i1.1616.

S. Satriani, S. Permatasari, and S. Agustina, “Studi pemanfaatan limbah abu kerak boiler terhadap kualitas bata beton,” TAPAK (Teknologi Apl. Konstr. J. Progr. Stud. Tek. Sipil, vol. 12, no. 1, p. 94, 2022, doi: 10.24127/tp.v12i1.2326.

E. Prianti, M. B. Malino, and B. P. Lapanporo, “Pemanfaatan abu kerak boiler hasil pembakaran limbah kelapa sawit sebagai pengganti parsial pasir pada pembuatan beton,” Positron, vol. 5, no. 1, pp. 26–29, 2015, doi: 10.26418/positron.v5i1.9744.

F. Zulkarnain and M. Y. Chair, “Penambahan abu cangkang kelapa sawit dengan bahan tambah silica gel ditinjau dari kekuatan tarik belah beton silinder,” J. Pendidik. Tek. Bangunan dan Sipil, vol. 2, no. 2, pp. 51–58, 2022, doi: 10.24114/ebjptbs.v8i2 DES.41867.

M. Irwansyah and A. T. Sihombing, “Analisa penggunaan paving block sebagai pengganti aspal beton pada lapisan permukaan jalan dengan menggunakan abu Kerak boiler,” in prosiding Seminar Nasional Multidisiplin Ilmu Universitas Asaha, 2020, no. September, pp. 843–850. [Online]. Available: http://jurnal.una.ac.id/index.php/semnasmudi/article/view/1604/1320

M. Lerry, E. Elhusna, and Y. Afrizal, “Perilaku kuat tekan beton dengan abu cangkang sawit sebagai pengganti sebagian semen,” J. Inersia, vol. 4, no. 2, p. 43, 2012, doi: https://doi.org/10.33369/ijts.4.2.43-50.

C. Pazlan, T. Budi Aulia, and P. Hasibuan, “Pengaruh substitusi aditif dan agregat terhadap kuat tekan beton mutu tinggi yang direndam pada air asin,” J. Civ. Eng. Student, vol. 1, no. 3, pp. 57–63, 2019, [Online]. Available: https://jim.usk.ac.id/CES/article/view/8984/5776

H. Heriyanti, L. Marlinda, S. Sutrisno, R. Rahmi, and R. Hanifah, “Paving block from residue of PS/LDPE/PP plastic pyrolysis mixed with palm oil bottom ash (POBA),” IPTEK J. Technol. Sci., vol. 33, no. 3, p. 201, 2022, doi: 10.12962/j20882033.v33i3.12915.

A. Gunawan, F. Abimanyu, and Y. Afrizal, “Pengaruh penggunaan abu sabut kelapa sawit sebagai bahan bahan penambah semen terhadap kuat tekan paving block,” J. Inersia, vol. 12, no. 1, pp. 12–17, 2020, doi: https://doi.org/10.33369/ijts.12.1.12-17.

F. Rahman and F. Fathurrahman, “Pemanfaatan hasil pembakaran limbah cangkang kelapa sawit sebagai bahan pengganti pasir pada pembuatan beton normal,” Media Ilm. Tek. Sipil, vol. 6, no. 1, pp. 30–40, 2017, doi: 10.33084/mits.v6i1.259.

G. Vitri and H. Herman, “Pemanfaatan limbah kelapa sawit sebagai material tambahan beton,” J. Tek. Sipil ITP, vol. 6, no. 2, pp. 78–87, 2019, doi: 10.21063/jts.2019.v602.06.

M. R. Palepy, “Pengaruh penambahan limbah abu cangkang kelapa sawit terhadap kuat tarik pada beton dengan bahan tambahan superplasticizer ( Studi Penelitian ),” J. Ilm. Mhs., vol. 1, no. 2, pp. 1–12, 2021, [Online]. Available: https://jurnalmahasiswa.umsu.ac.id/index.php/jimt/article/view/349/pdf

S. Wahyuni and N. Veronika, “Pembuatan paving block dinding beton berbahan baku abu boiler limbah sawit sebagai pengganti parsial pasir,” J. Sains dan Ilmu Terap., vol. 4, no. 2, pp. 17–19, 2021, doi: 10.59061/jsit.v4i2.48.

R. Yanita and G. Andreas, “Manfaat faktor konversi untuk pengujian kuat tekan paving block,” J. Ilmu Pengetah. dan Teknol., vol. 1, no. 2, pp. 79–87, 2017, doi: https://doi.org/10.31543/jii.v1i2.119.




DOI: https://doi.org/10.35308/jmkn.v10i1.9377

Refbacks

  • There are currently no refbacks.


Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.